Push-Pull props to accurately positioning on site of prefabricated panels and vertical formwork

What are Pull and Push props

The Pull and Push props are props that can perform double action: in fact, they work both in compression and in traction.

These are shoring systems necessary to support and stabilize, in maximum safety, many structures during the casting phase. I am able to effectively solve any kind of problem regarding the installation of vertical formwork.

How they are made

The Push-Pull props are made up of 2 sliding telescopic tubes, whose movement can be adjusted through a threaded ring nut and a pin placed in the holes of the internal tube.

It is precisely thanks to this structure that this type of props can perform a double action:

• compression, like classic props
• tension

Uses

Push-Pull props, due to their dual functionality, are essential for the safe support and stabilization of certain structures during the casting phase. They work under both compression and tension, effectively addressing any issues that may arise during the installation of vertical formwork.

Comipont Push-Pull props are both practical and adaptable. With the addition of special plates, they can be utilized and tailored to fit any formwork model available on the market. They are also highly beneficial for positioning pre-casted panels.

Types of Pull and Push props by Comipont

Making use of the most modern production systems and highly specialized personnel, Comipont creates 4 types of TS, which differ according to the different load and use capacities.

• TSL – Push-Pull Standard model equipped with sleeve
• TSDT – High duty Push-Pull equipped with sleeve
• TSM – High duty Push-Pull with Single nut
• TSH – High duty Push-Pull with Double nuts

All Comipont props are made with top quality and certified materials. Thy comply with the relevant reference standards.